[Retransfer] Tab
The retransfer settings screen enables you to set the conditions of retransfer to the card.
Front/Back side settings
Setting procedures
- The vertical axis shown in the setting area indicates the retransfer temperature, and the horizontal axis represents the retransfer speed.
- Click on the corresponding square to change the value. The selected value is indicated by [*].
- Setting a value toward the top right end increases the transfer force. However, the stronger heat also increases the deformation of the card.
- The colors below serve as a rough indicator for selection.
| Color | Description | |
|---|---|---|
 |
Green |
Standard value. |
 |
Light Blue |
Appropriate range. Recommended range when selecting a value other than the standard value. |
 |
Yellow |
Card bend increases. |
 |
Blue |
Retransfer defect may occur. |
 |
Red |
Do not select these values. |
Cautions
The different colors serve as a rough guide. The optimal value varies according to the card type as well as the environment in which the printer is used. Adjust the setting according to the actual environment.
It may take a while for printing to start when the retransfer temperature is changed.
There is only one standard retransfer temperature. Altering the retransfer temperature on one side changes the temperature on the other side.
The range of optimal values varies according to the [Card Type]. You can change the card type in the [Media Setting] Tab.
If the card type varies across printers, set the card type to use accordingly. The color of the setting area varies according to the card type in use.
Close
UV Speed
Setting for printing the retransfer film in two panels when UV ink is used.
It is used to set the speed of the retransfer heating roller during retransfer of the UV ink.
This setting helps to increase the retransfer speed without affecting the quality of the UV print.
Card Type
The appropriate value varies according to the type of card used. You can change the card type in the [Media Setting] Tab.
For more details, refer to Card Type in the “[Media Setting] Tab”.
[Update] button
Applies the selected value to the printer.
[Refresh] button
Displays the printer settings on the screen.